Here is the REV797 Graphics Kit Installation Guide.

1. Before installation, make sure your bike is clean and completely dry.

2. You may try splitting the wrap into two parts. Since most bikes are symmetrical, once you finish one side, the other side will be much easier. Most of our customers finish the installation within an hour.

3. The graphics kit is made of three layers of material. When peeling the wrap, always lift from the bottom layer, otherwise the kit may get damaged.

4. Before removing the backing, double-check that you’ve found the correct position for installation.

5. We don’t recommend using a heat gun before applying the kit, as this often creates bubbles. Instead, after installation, you can lightly heat the graphics kit and press it firmly to increase adhesion and extend its lifespan by 1–3 years.

6. If you have never successfully installed a graphics kit before, please record the full process on video so we can assist you if necessary.

7. If you’re experienced with graphics installation, we’d love for you to share your installation video or any tips to help more beginners enter the world of graphics kits. Thank you for your support!